|
| |
| ALLSAFE II |
 |
| Takes the slips and falls out of danger areas! |
ALLSAFE II is an easily applied, easy to use single part
non-skid coating system, providing greater scuff resistance and super
durability. This rubber base enamel coating gives a tougher, spark-proof
safety finish for exceeding OSHA requirements. Use it on loading docks,
ship decks, catwalks, tailgates & truck beds, food processing plants, locker
rooms, stair treads, bus aisles and more!
THE MIRACLE OF "BUILT-IN" TRACTION!
If you put ALLSAFE II under a microscope, you'll see a specially formulated
resin material blended with millions of diamond hard silica grit which takes the
slip and fall out of the slipperiest surfaces. These particles act as
snubbers to grab the soles of the person walking across the floor, ramp, loading
dock, etc. They make it virtually impossible to lose footing even when
operating under the most hazardous conditions. ALLSAFE II prevents costly
accidents and resulting litigation to say nothing of the needless suffering such
accidents cause. Every factory and institution should keep ALLSAFE II on
hand for slip-proofing all accident prone areas.
 | ALLSAFE II is not a paint - but a coating - the equivalent
of at least 10 times the thickness of conventional floor paint.
|
| ALLSAFE II has its own primer "built-in" - labor is saved
by using just one coat.
|
| ALLSAFE II is USDA authorized - low VOC.
|
| ALLSAFE II bonds to metal, wood and cement surfaces.
|
| ALLSAFE II is easy to apply. A stiff bristled brush
is all that is needed.
|
| ALLSAFE II dries in 5 - 6 hours. You never have a tie
up in production and traffic flow. |
ON LAND OR ON SEA! Indoor or Outdoor Use!
ALLSAFE II is highly resistant to alkali, detergents, mild acids, brake fluid,
oil, grease, etc. Approved for use in food or meat handling areas - for
marinas - boat docks, piers.
Five Colors Available - Gray, green, red,
yellow and black.
Coverage is 50 to 75 square feet per gallon.
WHERE ORDINARY COATINGS FAIL, ALWAYS SPECIFY
ALLSAFE II!
|
